COBB Silicone Exhaust Hanger 12mm x 35mm
The COBB Silicone Exhaust Hanger, part UNI-001-272, is a 12mm x 35mm silicone exhaust hanger that replaces a worn rubber isolator on any exhaust system using a matching hanger rod size.
Key Features
- Silicone construction resists heat and cracking better than stock rubber hangers
- Sized 12mm x 35mm to match a wide range of exhaust hanger rod spacings
- Slips over existing hanger rods for a simple no-tools installation
- Reduces exhaust vibration and rattling from a worn factory hanger
- Works on OEM or aftermarket exhaust systems using this hanger size
- Sold as a single hanger for spot replacement or full-system upgrades
Fitment
This silicone exhaust hanger is defined by its 12mm x 35mm dimensions rather than a vehicle application. It fits any exhaust hanger rod matching a 12mm pin diameter and 35mm center spacing.
Specifications
| Detail | Value |
|---|---|
| COBB Part Number | UNI-001-272 |
| Material | Silicone |
| Dimensions | 12mm x 35mm |
What’s Included
- One COBB silicone exhaust hanger
About COBB Tuning
COBB Tuning has engineered performance electronics, intakes, exhausts and suspension components for turbocharged platforms since 2003, building its Accessport ECU flashing device alongside record-tested bolt-on hardware for Subaru, Ford, Honda, Toyota and more.
FAQ
What size hanger rods does this fit?
It fits hanger rods with a 12mm pin diameter and 35mm center spacing.
Is this vehicle-specific?
No, it is a universal part defined by its dimensions rather than a vehicle application.
What material is this made from?
It is made from silicone.
Do I need tools to install this?
No, it simply slips over existing hanger rods by hand.
Why choose silicone over rubber?
Silicone resists heat and cracking better than a stock rubber hanger over time.
Is this sold individually or in a set?
The exact package quantity was not confirmed in sourced documentation. Verify before ordering multiples.
Is a warranty included?
Yes, it is covered by COBB’s Component Limited Warranty against manufacturing defects.
Can this be used on an aftermarket exhaust?
Yes, it works on any OEM or aftermarket exhaust using a matching hanger rod size.
Installation Instructions
- Support the exhaust system before removing any hangers to avoid strain on other mounts
- Locate the worn rubber hanger isolator on the exhaust system
- Slide the old hanger off the hanger rods on both the exhaust and the chassis side
- Stretch the new silicone hanger over the same hanger rods
- Verify the hanger is fully seated on both rods and the exhaust hangs level
- Release the exhaust support and check for adequate clearance from the chassis
Prop 65 Warning
WARNING: California residents can view COBB’s Proposition 65 warning notice on the product listing page for specific chemical exposure information.
